Use the correct power tool for your application. Use of dust collection can reduce dust-related hazards. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used.Loose clothes, jewellery or long hair can be caught in moving parts. Keep your hair, clothing and gloves away from moving parts. This enables better control of the power tool in unexpected situations. Keep proper footing and balance at all times. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. Remove any adjusting key or wrench before turning the power tool on.Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. Ensure the switch is in the off‐position before connecting to battery pack, picking up or carrying the tool. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. A moment of inattention while operating power tools may result in serious personal injury. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. Stay alert, watch what you are doing and use common sense when operating a power tool.Water entering a power tool will increase the risk of electric shock. Do not expose power tools to rain or wet conditions.There is an increased risk of electric shock if your body is earthed or grounded. Avoid body contact with earthed or grounded surfaces, such as pipes, radiators, ranges and refrigerators.Distractions can cause you to lose control. Keep children and bystanders away while operating a power tool.Power tools create sparks which may ignite the dust or fumes. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust.Cluttered or dark areas invite accidents. Save all warnings and instructions for future reference. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Read all safety warnings and all instructions. The machine can handle this kind of rough treatment.General power tool safety warnings WARNING The shock created by the chisel hitting the rock will loosen the The hammer down onto a hard rock as shown in the picture. There is however a simple fix: make sure the drill hammer is warm (room temperature), insert the chisel tool, and slam It can always happen and just warming up the machine to room temperature might not fix it. It can be caused by dirty grease, too much grease, old grease. This is not a pure "cold weather problem" as the Hilti manual suggests. Add a littleīit of fine cement dust to the mix and you understand why knocker might not "fly anymore". Some grease that you apply to the back of the tool penetrates up to the knocker and the knocker gets stuck. It was not cold when I had the problem but over time There is no temperature sensor in this machine. Very cold weather without explaining the cause. They mention that the hammer drill will not hammer in In fact, Hilti might have known about this problem area ever since they wrote the manual. As a result the machine will no longer hammer. I learned from other Hilti Hammer Drill owners that this is a very common problem! The knocker that flies backĪnd forth under changing air pressure can get stuck in cold gummed-up grease. They just wanted me to bring it to them for repair. However, they did not have any tips or suggestions. I called Hilti support to ask for advice because something like this is not normal. My Hilti TE60 failed to hammer after I had taken it out of the tools cabinet. The Hilti series of hammer drills are made for tough work with concrete and stone.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |